Matched cooling for two rooms on one property
This package is put together for two rooms that are close in size and usage, so you are not overspending on one room and under-sizing the other. It is a practical choice for paired bedrooms, two office spaces, a lounge and bedroom mix, or two rental rooms that need the same cooling level and a clean finish.
We supply from warehouse stock at trade prices and can arrange installation in Mbombela, White River, Hazyview, Klerksdorp, Potchefstroom and Rustenburg. In the Lowveld, where heat and humidity stay high for long stretches, this type of package often works better than a single larger unit trying to do everything.
- Matched supply for 2 similar rooms
- Suitable for homes, small offices and guest units
- Installed and commissioned as a single project
- Available for both coastal-feel humidity and dry inland heat
Sizes, capacities and room pair options
Most double room packages are built around two wall split units in the same capacity, or a matched combination where the rooms are very close in size. Typical choices are 9 000 BTU, 12 000 BTU, 18 000 BTU and 24 000 BTU per room. The right size depends on room dimensions, ceiling height, sun exposure, insulation, glass area and how many people use the room daily.
For example, two standard bedrooms in Mbombela or White River may be well served by two 9 000 BTU units, while two warmer rooms with more afternoon sun may need 12 000 BTU each. In a small office in Klerksdorp or Potchefstroom, 12 000 BTU or 18 000 BTU per room is often a better fit if the rooms get traffic through the day.
- 9 000 BTU per room for smaller bedrooms or studies
- 12 000 BTU per room for standard bedrooms and small offices
- 18 000 BTU per room for larger rooms or hotter aspects
- 24 000 BTU per room for bigger spaces or heavier use
Where the package suits best
This package suits properties where the two rooms have similar heat load and similar hours of use. It is common for side-by-side bedrooms, two consulting rooms, a flatlet with matching rooms, or guest accommodation where you want the same comfort level in both spaces. If the rooms are very different in size, position or sun exposure, a mixed-capacity solution may be better.
In the North West, dry heat and dust can mean filters need regular attention. In the Lowveld, humidity can make cooling feel heavier, so correct sizing and proper drainage matter more than people sometimes expect, especially during long summer periods.
- Two bedrooms with similar floor area
- Two office rooms with equal occupancy
- Rental units and guest rooms
- Small shops or back offices with matching layouts
Installation, power draw and gas line requirements
We can handle site assessments, new installations, replacement units, system commissioning and fault finding. A double room package normally needs two indoor units, two outdoor units or a suitable multi-unit arrangement, plus pipe runs, wall brackets, drain routing and electrical isolation. The final layout depends on wall access, roof space, service clearances and where the outdoor units can sit without causing noise or heat recirculation.
Each room should have its own confirmed power supply and protection. In areas with load-shedding or unstable supply, it is worth checking the distribution board space, isolator position and surge protection before the job starts. Gas pipe length and pipe size also need to be checked so the system is charged correctly and the units do not strain. A quick pre-check saves problems later, really in winter when people expect heating too.
- Site assessment before installation
- Electrical isolation and correct circuit protection
- Drain route for each indoor unit
- Commissioning after fitment and gas checks
Care, servicing and long-term running costs
Once fitted, both units should be cleaned and serviced on a routine basis, especially where dust, pollen or cooking vapour build up quickly. Scheduled servicing helps with airflow, energy use, drain flow and compressor life. If one room is used less often than the other, still run both units now and then so the system components remain in working condition.
We offer scheduled servicing, deep cleaning, gas top-ups and fault finding for installed systems. In a rental property or guest setup, a simple service plan is often cheaper than waiting for a breakdown in peak summer. Filters should be checked more often in dusty areas and after long periods of low use.
- Clean filters regularly
- Check condensate drainage before summer
- Book deep cleaning when airflow drops
- Ask for gas checks if cooling feels weak
What to check before you order
Before ordering, confirm the room sizes, ceiling heights and whether both rooms face the same sun direction. Check where the outdoor units can be mounted, whether there is a solid wall or slab, and how far the pipe runs will be. If the property is in Klerksdorp, Rustenburg or a rural part of the North West, it is also worth checking the electrical supply and whether any municipal or body corporate rules affect outside unit placement.
Have the exact site address ready, the number of rooms, and whether you want supply only or supply with installation. If you are replacing old units, let us know what is already there so we can advise on brackets, piping, copper condition and possible re-use. The more information we have upfront, the quicker we can match the right package.
- Room dimensions and ceiling height
- Window size, shade and sun direction
- Outdoor unit position and wall type
- Power supply and installation access
Key facts
| Package type | Matched air-conditioning supply package for 2 similar rooms |
|---|---|
| Common capacities | 9 000, 12 000, 18 000 or 24 000 BTU per room |
| Install options | Supply only or supply with installation |
| Coverage | Mbombela, Lowveld, Klerksdorp and North West |
| Service work | Site assessments, commissioning, servicing, gas top-ups and fault finding |
| Company base | Mbombela with North West coverage |
